Rough Country 525.20 - Manual (Page 4)

Note—It is not unusual to have a camber issue (the top of the tires lean outward) and a
toe issue (tires pointed in) when this kit is first installed and has not been driven or
aligned. When aligned a new caster/camber bushing may be needed to achieve proper
caster and camber angles.
22. Have a qualified alignment center realign front end. Toe-in must be reset. Caster angle was kept intact by the ra-
dius arm lowering brackets, and is non-adjustable. Set camber angle at ¾º to 1º degree positive with preferably the
driver side 1/8º to ¼º more positive than the passenger side. The extra driver side caster improves drivability, es-
pecially on high-crowned driving surfaces. When the springs settle (after 100miles or so) caster will read the pre-
ferred ¼º to ½º positive.
23. Wheels must be retightened at 50 miles.
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering gear for interference and proper working order. Test brake system.
2. Perform steering sweep. Check to ensure brake hoses have sufficient slack and will not contact rotating, mobile,
or fixed members, adjust lines/brackets to eliminate interference and maintain proper working order. Failure to
perform inspections may result in component failure.
3. Bump stops and extensions must be in place on all vehicles! Note: Allowing suspension to over extend by neglect-
ing to install or maintain stops and extensions may cause serious damage to factory components.
4. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
MAINTENANCE INFORMATION
It is the ultimate buyer's responsibility to have the bolts/nuts checked for tightness after the first 100 miles and then
every 1000 miles. Wheel alignment, steering system, suspension, and driveline systems, must be inspected by a quali-
fied professional mechanic at least every 3000 miles.
Kit Contents:
7510 Box
1-Drivers Side Axle Bracket
1-Passengers Side Axle Bracket
1-Driver side Axle Tab Bracket
1-Drivers Side Radius Arm Bracket
1-Passengers Side Radius Arm Bracket
1-Kit Bag including
26-7/16”
Flat Washers
14-7/16”x1 ¼” Bolts
14-7/16” Lock Nuts
2-9/16” Flat Washers
1-9/16”x3.5” Bolt
Driver Side Axle Bracket
Pass Axle Bracket
Passenger Side Radius Arm Brk.
Driver Side Radius Arm Brk.
Driver Side Axle Tab Bracket