Rough Country 734.20 - Manual (Page 8)

FINAL RIDE HEIGHT ADJUSTMENT INSTRUCTIONS
Jack up the front of the vehicle and adjust the torsion bar adjuster bolt and set ride height by turning the bolt clockwise.
Be sure to grease the adjuster bolt before adjusting. Lower the vehicle to the ground and manually bounce the vehicle.
Check ride height. If more list is desired to Level the vehicle front to back repeat the process above until desired height is
achieved.
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering gear for interference and proper working order. Test brake system.
2. Perform steering sweep. Check to ensure brake hoses have sufficient slack and will not contact rotating, mobile, or
fixed members, adjust lines/brackets to eliminate interference and maintain proper working order. Failure to perform
inspections may result in component failure.
3. Bump stops and extensions must be in place on all vehicles! Note: allowing suspension to over extend by neglect-
ing to install or maintain stops and extensions may cause serious damage to OE and related components.
4. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
5. Readjust headlights to proper settings if applicable.
6. Check turning clearances. Making sure all parts allow for full turning radius.
7. For alignment, both sides inner and outer tie rod ends may need to be trimmed approximately 1/2” to allow
tie rod end to be threaded into the alignment sleeve for proper adjustment. Please note this may not have to
be performed on all vehicles.
Rear Cross Member Rear RC Shock (2 )
Sway Bar Drops (2)
Knuckle Adapter (2)
Front RC Shock (2)
Bump Stop Ext (4)
Rear U-Bolt (4)
Rear Lift Block (2)
Frt Cross Member Brkt
Brake Valve Brkt
Square Washer (8)
Brake Line Brkt (2)
Diff Drop Brkts
PRODUCT LAYOUT—KIT CONTENT
Diff. Drop Fasteners Cross Mbr Fasteners Knuckle Fasteners Sway Bar Fasteners Brake Line Fast. Bump Stop Fast
4—7/16” 1.25” Bolts 4- 5/8” x 4” Bolts 2—5/8” 2 1/2”” Bolt 4 - 5/16” 1” Bolts 2 - 3/8” 1” Bolts 4—3/8” 1” Bolt
1—7/16” 1.5” Bolt 4—5/8” Nuts 2—5/8” Nuts 4—5/16” Nuts 2—3/8” Nut 4—3/8” Nuts
5—7/16” Lock Nuts 8-Square washers 2-Cotter pins 8—5/16” Washer Brake Valve Brkt 8—3/8” Washer
10-7/16” Washers 4-14MM bolts 2—5/16” 1” Bolt
4-14mm nuts 2- - 5/16” Nut
8-Flar Washers 4—5/16 Washer
Rear Cross Member
Drop Brackets