Rough Country 789.22 - Manual (Page 15)

37. Locate the 4 sway bar link sleeves. Insert the sleeves into the sway bar link bushings. Using the supplied .500-16 x
2.75” bolts, washers and nuts from 1681bag3, install the sway bar links to the sway bar, and axle mount., and
tighten using a 13/16” socket and 7/8” wrench. . Make sure the bolts are installed with the HEAD of the bolt
toward the tire.
38. Install the rear RCX 2.2 series shocks part # 660586 using the factory hardware, using a 16mm socket for the top,
and a 18mm socket for the bottom. Shaft end of the shock will be pointed down. See Photo 60.
39. Install the rear bump stop spacers on the axle and secure with the supplied 3/8” x 3/4” bolts, washers, and nuts from
1609bag6. See Photo 61.
40. Remove the rubber brake line from the steel line using a 12mm wrench as shown in Photo 62 and remove the brake
line from the caliper using a 15mm wrench.
41. Install the new bracket using a 10mm wrench and stock hardware in factory location. Install the new brake line on
the hard line and tighten. Install spring clip as shown in Photo 63 and secure the caliper end of the brake line with
supplied crush washers, using a 15mm wrench to tighten.
42. Reinstall the rear tires/wheels , using a 19mm deep well socket.
43. Lower the vehicle to the floor.
44. Install the front track bar into the axle bracket, you may have to turn the steering wheel to move the axle left and
right for the bolt hole to align.
45. Next measure from each tire to the frame making sure the front axle is centered. If needed the track bar can be
removed and adjusted to the correct length to center the axle. After the adjustment all complete tighten the jam nut
with a adjustable wrench.
PHOTO 60
PHOTO 62
PHOTO 61
PHOTO 63