Rough Country 562P User Manual
Rough Country For the car

05-09 F250 SUPERDUTY 3” LIFT KIT
92148600
Kit Contents:
9284– Front Coil Springs
Kit Boxes containing
2-Radius Arm Drop Brackets
2-658640 Front Shock
2-650377 Rear Shock
2-142731 Front Shock Bushings
2-2”
Blocks
4-5/8” x 3 5/8” x 16” U-Bolt
1-Track Rod Bracket
1486 Bag1:
For Front Radius Arm Drop Brackets:
4-3/4” x 5” Bolts
4-3/4”
Nuts
8-3/4”
Washers
4-Crush
Sleeves
1487 Bag:
For Shock Absorbers:
4-Shock
Bushings
4-Sleeves
Tools Needed:
18mm Socket
18mm Wrench
19mm Socket
19mm Wrench
21mm Socket
21mm Wrench
24mm Socket
30mm Socket
Jack Stands
Floor Jack
Wheel Chocks
1 1/8” Socket
1 1/8” Wrench
Reciprocating Saw
Tap Measure
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure
you have all the needed parts and understand where they go. Also please review the tools needed list and make sure
you have needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly larger/heaver tires and wheels are used. Take
this into consideration while driving. Also, speedometer recalibration is necessary when larger tires are installed.
Do no add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height of
the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts
voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims.
We will not be responsible for any product that is altered.
This 3” suspension system was developed for 35x12.50x17 tire on an 8” wheel.
The 3” front system comes standard with a 2” block and u-bolt set-up for the rear to give the truck a level look. Personal
preference, OE options, and aftermarket add-ons may require additional lifting options. One option on the SD is factory
contact overload springs (a set of springs that sit above the leaf springs and that under load come in contact with two
stops off of the frame) Vehicles equipped with factory contact overloads need a longer u-bolt and will require kit box
6558. Please verify the correct kit has been ordered and received prior to proceeding. On vehicles with dual rear
wheels the use of blocks and longer u-bolts is not recommended and should not be installed.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun vi-
sor / dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling charac-
teristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation
instructions on too the vehicle owner for review and to be kept in the vehicle for its service life.
Torque Specs:
Size Grade 5 Grade 8
7/16” 45 ft/lbs 60 ft/lbs
1/2” 65 ft/lbs 90 ft/lbs
9/16” 95 ft/lbs 130 ft/lbs
5/8” 135 ft/lbs 175 ft/lbs
3/4” 185 ft/lbs 280 ft/lbs