Rough Country RC610 - Manual (Page 6)

29. Install the .25” self tapping bolt into supplied radiator drop brackets using a deep well 7mm socket and hammer, by
striking the bracket and pushing it on the stud. See Photo 19. Make sure stud is secured into bracket.
30. Using a 7/16 socket remove the six bolts that hold radiator on. See Photo 20. Note: Use caution when removing
the radiator mounting bolts to not allow the radiator to fall and possibly damage the radiator or surrounding
components.
31. Remove all 6 body clip from core support and install one on each of the radiator drop brackets. The clips will install
in the middle hole on the radiator brackets. See Photo 21 & 22.
32. Install radiator support drop brackets onto core support using the supplied washer 1/4” washers and 1/4” nuts.
Tighten bolts using 7/16” socket and make sure brackets are hanging straight down. See Photo 23.
33. Install radiator using stock hardware and use a 7/16” socket to tighten. See Photo 24.
Photo 19 Photo 20
Photo 21 Photo 22
Photo 23 Photo 24
Install 1/2” studs Remove the radiator bolts
Remove the stock clips Install the clips on the supplied brackets
Make sure all brackets are straight
Reinstall the radiator shroud