Rough Country 1627 - Manual (Page 2)

NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product
should have a “Warning to Driver” decal installed on the
inside of the windshield or on the vehicle’s dash. The decal
should act as a constant reminder for whoever is operating
the vehicle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install
the warning decal and forward these installation instructions
on to the vehicle owner for review. These instructions
should be kept in the vehicle for its service.
TOOLS NEEDED
Assorted Metric wrenches Floor jack
Assorted standard wrenches Hammer
11/32” drill bit Jack stands
Drill Center punch
INSTALLATION INSTUCTIONS
1. Chock the rear wheels. Using a floor jack, jack up the
front of the vehicle and place jack stands directly be-
hind the front control arm mounts to support the vehicle.
Lower floor jack, but do not remove.
2. Loosen and remove the upper control and lower control
arms at the frame end one side at a time. Retain hard-
ware for reuse.
3. Using 13mm wrench, remove the alignment shoe and
shims from lower control arm bracket as shown in Fig-
ure 1 and 2. Retain for reuse.
4. Install the Rough Country lower control arm drop
bracket and the upper control arm drop bracket as
shown in Figure 3 and 4 with the supplied 1/2” x 4 1/2”
bolts and crush sleeves in the bottom hole and using
the supplied 10mm x 90mm hardware and crush sleeve
in the upper mount. Also see Figure 5 to see how up-
per control arm will mount.
FIGURE 1
View from center of vehicle to passenger side.
FIGURE 2
View from side on passenger side.
Remove alignment
shoe from inside
and any shims be-
hind the pocket.
View from front of passenger side bracket.
FIGURE 4
FIGURE 3
View from side of passenger side bracket.
1/2 x 4.5”
Bolt Loca-
tion
10mm x 90mm Bolt
and Spacer Sleeve
FIGURE 5
View showing
UCA installation
location.
1/2” x 2 5/16”
Spacer Sleeve