Rough Country 1627 - Manual

Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list on this page. Be sure
you have all needed parts and know where they go. Also please review tools needed list and make sure you have all of
the needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.
Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this
into consideration while driving.
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
This kit is an add on kit—it will not lift your vehicle without additional product. This kit is used to lower the upper and
lower control arms. Lowering the arms mounting point reduces control arms angle and substantially improves ride qual-
ity and handling. This kit can be used with stock lower control arms and with stock upper control arms at 4.5” of lift. For
additional lift longer adjustable control arms are needed. To determine length to adjust arms use chart below.
KIT CONTENTS:
1-Dr control arm drop brkt
1-Pa control arm drop brkt
1-Dr upper control arm brkt
1-Pa upper control arm brkt
1-Dr RCX bracket brace
1-Pa RCX bracket brace
1-1627 poly bag
4-5/16” x 1 1/4” bolt
4-5/16” flange nuts
4-5/16” washers
2-10mm X 90mm bolt
2-10mm nuts
4 10mm washers
2– 2” crush sleeves
2-1/2” x 4 1/2” bolts
2-1/2” lock nuts
4-1/2” washers
4-3/8” self tap. bolts
2– 1/2” x 2 5/16”Crush
Sleeves
92162700
Lift Height Lower Control Arm Upper Control Arm
4.5” 15.75” - Stock Length 15” - Stock Length
6” 15.875” 15.125”
8” 16.25” 15.524”
Upper Control Arm Bracket
RCX Brace
LCA Bracket LCA Bracket
JEEP XJ 84-01 CONTROL ARM RELOCATION
BRACKET AND RCX BRACE KIT