Rough Country 1064 User Manual
Page 3

6. Carefully remove the bumper / grill from vehicle. See Photo 7.
7. Remove the sway bar from the frame with a 18mm socket. See Photo 8.
8. Allow the sway bar to hang.
9. The 4 holes marked will need to be drilled using a 9/16” drill bit. See Photo 9.
10. Mark the frame as shown, measuring across 3 1/2” and 1” up from the bottom of the opening. See Photo 10.
11. Trim the corner and slot the frame using a reciprocating saw as shown in Photo 11 to allow the winch frame bracket
to be installed. Paint area to prevent rust.
12. Slide the supplied plate between the bottom of the frame and the sway bar, line up holes in frame and secure with
the stock sway bar hardware. See Photo 12. Tighten using a 18mm socket.
Photo 7
Photo 8
Photo 9
Photo 10
Photo 11
Photo 12
REMOVE THE BUMPER FROM THE GRILL
REMOVE THE SWAY BAR FROM THE FRAME
ENLARGE THE HOLES
MARK FRAME TO BE CUT
FRAME SHOWN TRIMMED
PLACE SUPPORT BRACKET ON FRAME
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)