Rough Country 1080 - Manual (Page 9)

Chevrolet Install Instructions
1. Disconnect the positive and negative cable from the battery and secure them out of the way.
2. If the truck has lower fog lights unplug the driver and passenger side at the connector. See Photo 1.
3. Using a 15mm socket remove the bumper bracket bolt on the driver side. See Photo 2.
4. Remove the side support bolts with a 15mm socket. See Photo 3.
5. On the driver side using a 21mm socket remove the two nuts from the bumper bolts on the outside of the frame rail.
Pull the two bolts out of the frame.
6. Next use a 18mm socket to remove the tow hook bolts.
7. Repeat steps 3-5 on the passenger side.
8. Reaching inside the bumper pull out the plastic clips holding the rubber splash guard to the bumper. See Photo 4.
8. Remove the bumper from the truck and set aside.
9. Remove the radiator shielding from the truck. See Photo 5. Use a flat head screw driver to pull out the plastic pins.
10. Next the grill shell will need to be removed, using a 10mm socket to remove the upper bolts of the grill assemble.
See Photo 6.
PHOTO 6
PHOTO 4
PHOTO 5
PHOTO 3
PHOTO 2 PHOTO 1