Rough Country 5060 - Manual (Page 3)

9. Install new bracket into place and loosely clamp making sure the ¾” holes on the bracket are on the outside of the
frame rail. Measure 43.50 inches from the center of the bolt hole of the front bracket back along the frame rail to the
center of the bushing hole of the rear bracket. This must be done as accurately as possible. See Photo 5.
10. Using the bracket as a template, mark hole centers with a center punch. Then drill all three holes with a ½”drill bit
going all the way though both sides of the frame rails. Install the 1/2” x 3 1/2” bolt in center hole and then drill the two
remaining holes to 49/64” on the outside of the frame rail. See Photo 4,5,6.
11. Now insert the supplied spacer sleeve into the top holes being very careful not to drop sleeve inside frame rails and
install the ½” x 3 ½” bolts. Install the supplied bushings in the bracket as shown. See Photo 7 & 8. Tighten using a
3/4” socket / wrench.
12. Reverse the springs and install what was the rear part of the leaf springs in the front mount using the supplied 9/16”
x 4 1/2” bolts, nuts and washers. Only slightly tighten at this time. Raise rear of the leaf spring up to meet the new
rear bracket. Note: On the small eye of the spring, remove bushings and install one shim behind each bushing and
replace. See Photo 9 & 10.
Photo 5 Photo 6
Photo 7 Photo 8
Photo 9 Photo 10