Rough Country 5060 - Manual

CJ SHACKLE INVERSION KIT
Thank you for choosing Rough Country for all your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list on this page. Be sure
you have all needed parts and know where they go. Also please review tools needed list and make sure you have
needed tools.
PRODUCT USE INFORMATION
Rough Country makes no claims regarding and will not be responsible for any product that is altered.
We will be happy to answer any questions concerning the design, function, and correct use of our products.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
This kit is designed to ease the harsh ride of the leaf sprung vehicle. Repositioning the shackle to the rear of the spring
allow the leaf spring to move freely through various road conditions. Stock shackles are recommended for this kit.
Installing lifted or longer than factory shackles could create driveshaft vibration and could cause the driveshaft
to separate when the suspension is fully extended.
Kit Contents:
Driver Shackle Bracket
Pass Shackle Bracket
Driver Fr Stationary Bracket
Pass Fr Stationary Bracket
Cross Brace
92506000
Tools Needed:
9/16” Socket / Wrench
3/4” Socket / Wrench
13/16” Socket
7/8” Socket
1 1/8” Socket
Center Punch
Hand Grinder
Hammer
3/8” Drill Bit
1/2” Drill Bit
49/64” Drill Bit
Drill
Tape Measure
Torque Specs:
Size Grade 5 Grade 8
3/8” 30 ft/lbs 35 ft/lbs
1/2” 65 ft/lbs 90 ft/lbs
9/16” 95 ft/lbs 130 ft/lbs
3/4” 185 ft/lbs 280 ft/lbs