Rough Country 774S - Manual (Page 10)

8. Install the shock on the lower shock mount with factory
hardware and tighten using a 17mm wrench.
Note: The
RCX 2.2 Series Shock Absorber is designed to run the
piston down as shown. See Photo 7.
9. Install new brake line brackets in
Photo 8 using stock and
supplied 5/16 x 3/4 ” bolts. Tighten using 12mm wrench
and 13mm wrench to tighten.
10. Install new emergency brake cable brackets on the driver
and passenger side as shown in
Photo 9 using stock
hardware to secure the new bracket to the stock location.
Secure the new bracket to the stock brake bracket using
5/16 x 1
” bolts . Tighten using a 12mm wrench and 13mm
wench to tighten.
11. Install tires and wheels.
12. Jack up the rear of the vehicle and remove the jack stand.
13. Lower the vehicle to the ground and check to make sure that all ABS and brake lines are clear from any moving
parts.
POST INSTALLATION INSTRUCTIONS
1. Check and recheck all fasteners for proper torque. Check to ensure there is adequate clearance between all rotat-
ing, mobile, fixed and heated members. Check clearance between upper control arm and sidewall of tire for proper
clearance. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. Cycle the steering from full turn to full turn to check for clearance. Failure to perform in-
spections may result in component failure.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
4. Adjust headlights to proper settings given increased vehicle height.
5. An alignment will need to be performed on this vehicle to set proper alignment.
Photo 9
Driver Side Shown
Photo 8
Photo 7
Thank you for choosing Rough Country for all your suspension needs and don't forget
to visit us on the web @ www.roughcountry.com for your off road needs.