Rough Country 563.20 - Manual (Page 3)

12. Support both radius arms with jack stands. Using a 24mm wrench, and socket remove the bolt holding the upper
control arm to the axle. Retain stock hardware for reuse. See Photo 7.
13. Using a 1 1/8” wrench, and socket remove the bolt holding the upper control arm to the frame. See Photo 8.
14. Insert the radius arm drop bracket into the stock location. See Photo 9.
15. Bolt into place using the supplied spacer sleeves and 3/4” x 4 3/4” bolts, nuts and washers provided in the kit bag.
See Photo 10. Do not tighten at this time.
16. Install the radius arms to the new drop bracket with factory hardware in the lower holes. See Photo 11.
17. Attach the arm to the axle using the stock hardware. Note: it may be necessary to raise or lower the truck to align
the holes.
18. Reattach the ABS wire to the radius arm.
19. Using a 21mm wrench and 19mm wrench socket remove the factory track bar bracket from the frame. Retain stock
hardware for re-use.
20. Position the Rough Country track bar bracket on the frame in the same position as the original and secure using the
factory hardware. Tighten hardware using a 18mm wrench. See Photo 12.
Photo 9
Photo 11
Photo 10
Photo 12
Photo 7 Photo 8