Velleman WS2800 Software User’s Guide - Manual (Page 14)

P a g e | 14
DETAILED INSTRUCTIONS
To tell the weather station to start communicating with the
software, press and hold the button showing a down arrow
until the weather station beeps (approximately 3-4 seconds).
When you hear the beep, this indicates that the weather
station is now searching for the USB communication device.
While the weather station searches for a USB communication
device, it will display ‘SCn-PC’ next to the time.
The weather station should now be in scan mode. Now on your
computer, click the Synchronize button .
When the weather station finds the USB device, it will beep and
the display will show ‘PC’ in the lower line (unless the date is
being displayed). The software will then update with the current
weather data from the display.
This indicates that the weather station has successfully connected (“synchronized”) with the USB communications
device (software).
Note: If the date is being displayed, you will not see “PC”.
Note: It can take up to 30 seconds for the synchronization to complete.
Note: You may have to try the synchronization process more than once.