Trek 603 Piezo Driver-Power Amplifier - Manual

The Trek Model 603 is a high-voltage DC power amplifier/piezo
driver designed to provide precise control of output voltages in
bipolar or unipolar ranges that are customer specified within a
range of available settings. The instrument achieves the
accurate output responses and high slew rates demanded by
reactive loads by utilizing a four-quadrant active output stage that
sinks or sources current into reactive or resistive loads.
The Model 603 is configured as a non-inverting amplifier. An
inver ting configuration is optionally available. Both
configurations are available in single or dual channel packaging.
They are operable on a bench top or in a 19-in rack.
Trek Model 603
Piezo Driver/Power Amplifier
Key Specifications
! Available Voltage Ranges:
! Output Current Range: peak AC for less than 1 ms
! Slew Rate: Greater than 100 V/
!
!
0 to ±125 V DC or peak AC or
0 to -250 V DC or peak AC or
0 to +250 V DC or peak AC
0 to ±40 mA DC or ±80 mA
µs
Large Signal Bandwidth (5% distortion): DC to greater than 150 kHz
DC Voltage Gain: 50 V/V or 25 V/V
TREK, INC. • 190 Walnut Street • Lockport, NY 14094 • USA • 800-FOR TREK
716-438-7555 • 716-201-1804 (fax) • www.trekinc.com • [email protected]
Features and Benefits
!
!
!
!
!
!
Four-quadrant output for driving capacitive loads
Up to two independent amplifier channels in one enclosure
Short-circuit protected for equipment protection
! Reprogrammable factory-set output configurations
! All solid-state design for maintenance free operation
Low output noise for ultra-accurate outputs
compliant
NIST-traceable Certificate of Calibration provided with each unit
Typical Applications Include
! Driving piezoelectric actuators
! Modulating electrooptics
! Electrostatically controlling ion beams
! Providing remote ON/OFF capabilities for
automated or computer controlled systems