Milton CAT D100-6_S 100 kW EMCP4.2 Engine__Gen Control Panel - Manual (Page 2)

EMCP 4.2 GENERATOR SET CONTROLLER
LEHE0138-00 2
STANDARD FEATURES
Generator Monitoring
• Voltage (L-L, L-N)
• Current (Phase)
• Average Volt, Amp, Frequency
• kW, kVAr, kVA (Average, Phase, %)
• Power Factor (Average, Phase)
• kW-hr, kVAr-hr (total)
• Excitation voltage and current (with CDVR)
• Generator stator and bearing temp (with optional module)
Generator Protection
• Generator phase sequence
• Over/Under voltage (27/59)
• Over/Under frequency (81 O/U)
• Reverse Power (kW) (32)
• Reverse Reactive Power (kVAr) (32RV)
• Overcurrent (50/51)
Engine Monitoring
• Coolant temperature
• Oil pressure
• Engine speed (RPM)
• Battery voltage
• Run hours
• Crank attempt and successful start counter
• Enhanced engine monitoring (with electronic engines)
Engine Protection
• Control switch not in auto (alarm)
• High coolant temp (alarm and shutdown)
• Low coolant temp (alarm)
• Low coolant level (alarm)
• High engine oil temp (alarm and shutdown)
• Low, high, and weak battery voltage
• Overspeed
• Overcrank
Control
• Run / Auto / Stop control
• Speed and voltage adjust
• Local and remote emergency stop
• Remote start/stop
• Cycle crank
Inputs & Outputs
• Two dedicated digital inputs
• Six programmable digital inputs
• Six programmable form A dry contacts
• Two programmable form C dry contacts
• Two digital outputs
Communications
• Primary and accessory CAN data links
• RS-485 annunciator data link
• Modbus RTU (RS-485 Half duplex)
Language Support
Arabic, Bulgarian, Chinese, Czech, Danish, Dutch, English, Estonian,
Finnish, French, German, Greek, Hungarian, Icelandic, Italian, Latvian,
Lithuanian, Japanese, Norwegian, Polish, Portuguese, Romanian,
Russian, Slovak, Slovene, Spanish, Swedish, Turkish
Environmental
• Control module operating temperature: -40°C to 70°C
• Display operating temperature: -20°C to 70°C
• Humidity: 100% condensing 30°C to 60°C
• Storage temperature: -40°C to 85°C
• Vibration: Random profile, 24-1000 Hz, 4.3G rms