Milton CAT G300LG 300kW_375kVA Battery Charger - Manual

2 Amp and 10 Amp
Battery Chargers
Specifications 2 Amp 10 Amp
Nominal Input 120 VAC 120 VAC
Operating AC Line Voltage Range 108 to 132 Volts AC 108 to 132 Volts AC
Input AC Line Frequency 50/60 Hz 50/60 Hz
Battery Fuse 5 Amps 15 Amps
Nominal Charge Rate 2 Amps 10 Amps
Equalize Voltage 13.8 Volts
Float Voltage 13.8/27.6 13.0/26.0
Current @ Equalize to Float Transition 5 Amps
Battery Under-voltage shutdown 11/22 Volts 11/22 Volts
LED Indicators
AC Line Voltage
Green LED On Green LED On
Battery Connected and Charging Yellow LED On Yellow LED On
1 > 0.5 Amp 1 > 2 Amp
Battery Current Drain 30 milliamp 30 milliamp
AC Line Connection Terminal Block Terminal Block
Battery Connection Internal to Control Panel Internal to Control Panel
Control Connection AC Power Fail Relay
Form C 2 Amp Rating
UL Listed Yes Yes
NFPA110 Compliant No Yes
The Olympian 2 & 10 Amp 12 and
24 Volt charger is designed to work
with the H control panel is mounted
within the H100 Enclosure. It
provides the ultimate in automatic
battery voltage maintenance.
The 2 amp is self regulating and
produces instantaneous output
current adjustments to keep the
battery charged to an optimum level.
Battery voltage is read on the H100
control panel readout The 10 amp
has automatic float and equalizer
control. It precisely monitors the
battery’s voltage and automatically
activates the correct charging mode.
The charge rate is limited and
controlled to efficiently and safely
maintain ideal battery levels under
varying conditions.
The equalizer system uses a control
circuit to limit charging current to 10
amps. When battery voltage drops
beyond a pre-set level, charging
current increases to 5 amps and
then to the 10 amp charge rate if
needed. When the battery reaches
maximum charge the charger
switches to equalize mode. At
equalize, just enough current is
supplied to maintain the battery at
or above 13/26 volts. Battery voltage
and Charging current are read at the
digital display on the H100 panel.
Battery Charger shown from inside of Control Panel Enclosure.
Connections are made via an attached harness.
Information contained in this publication may be considered confidential.
Discretion is recommended when distributing.
Materials and specifications are subject to change without notice.
CAT, CATERPILLAR, OLYMPIAN, their respective logos and ''Caterpillar Yellow'', as well as corporate and product
identity used herein, are trademarks of Caterpillar and may not be used without permission.
www.CAT-ElectricPower.com
© 2009 Caterpillar
All rights reserved.
Printed in U.S.A.