VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) 4 … 20 mA_HART - two-wire, approval according to LPR radio standard - Manual (Page 32)

6 Set up with the indicating and adjustment
module
6 .1 Insert indicating and adjustment module
The indicating and adjustment module can be inserted into the sensor
and removed any time. Four positions displaced by 90° can be
selected. It is not necessary to interrupt the power supply.
Proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in the requested
position onto the electronics and turn to the right until it snaps in
3 Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Fig. 27: Insertion of the indicating and adjustment module with single chamber
housing into the electronics compartment
32 VEGAPULS 62 • 4 … 20 mA/HART - two-wire, approval according to LPR radio standard
6 Set up with the indicating and adjustment module
41718
-EN
-120301