7 setup with pactware, 1 connect the pc – VEGA PLICSRADIO R62 Wireless processing unit User Manual

Page 25

7 Setup with PACTware

PLICSRADIO C62 • Wireless processing unit for PLICSRADIO T62

32627-EN-130701

7 Setup with PACTware

7.1 Connect the PC

For a brief connection of the PC, e.g. for parameter adjustment,

connection can be carried out via the VEGACONNECT 4 interface

converter. The necessary I²C interface on the front is available on all

instrument versions. On the computer side, connection is carried out

via the USB interface.
Note:

The parameter adjustment of PLICSRADIO C62 cannot only be

carried out via this interface connection but also the sensor at the

beginning of the measuring chain.

OPEN

TWIS

LOCK

Fig. 7: Connection via VEGACONNECT
1 USB interface of the PC

2 I²C connection cable of VEGACONNECT 4

3 I²C interface

With the Ethernet interface, the instrument can be connected directly

to an existing PC network. Any standard patch cable can be used.

A cross-over cable must be used when connecting the instrument

directly to the PC. To reduce EMC interferences, the supplied split fer-

rite should be connected to the Ethernet cable. Each instrument can

then be accessed from anywhere in the network by an unique Host

name or its own IP address. The parameter adjustment of the instru-

ment via PACTware and DTM can be carried out from any PC. The

measured values can be made available to individual users within the

company network as HTML chart. As an alternative, the independent,

time or event-controlled transmission of measured values via e-mail

is also possible. The measured values can also be called up via a

visualisation software.
Note:

To respond the instrument, the IP address or the Host name must

be known. You can find this information under the menu item "Device

settings". If you are modifying these specifications, the instrument

must be restarted afterwards. Then the instruments can be reached

from everywhere in the network via its IP address or the Host name.

These specifications must be also entered in the DTM (see chapter

"Parameter adjustment with PACTware").

Connection of the PC via

VEGACONNECT

Connection of the PC via

Ethernet