VEGA VEGABAR 41 HART - Manual (Page 29)

VEGABAR 41 (HART ® ) 29
Setup
In the window "Integration time“ you can enter
a time of max. 10 seconds. Then click to
OK .
Sensor parameter adjustment –
Outputs
Click in the window "Instrument data param-
eter adjustment“ to
Outputs .
Click in the window "Conditioning“ to Current
output .
In the window "Current output“ you can set
the strength of the current in case of failure
(e.g. line break). Furthermore the current can
be inverted, i.e. at 0 % the current output is
20 mA, at 100 % 4 mA. Click to
Save when
you have modified the adjustment.
Click in the window "Conditioning“ to Display
of measured value (only possible if you
have connected a display on VEGABAR).
In the window "Sensor-Display“ you choose
the parameter and the unit which the display
should indicate. If you choose "scaled“, you
can enter the figures corresponding to 0 %
and 100 %. Click to
Save when you have
finished the adjustments in this window.