VEGA VEGABAR 41 HART - Manual (Page 19)

VEGABAR 41 (HART ® ) 19
Depending on parameter:
change value (increase) or
choose out of a list
Choose menu item or interrupt
adjustment
Depending on the menu item, save
the adjusted value or change the
menu level
Depending on parameter:
change value (decrease) or
choose out of a list
Indication of:
- measured value
- functions in menu
▼ Jump to the menu below
with the OK key
▲ Reset to the menu above
with the OK key
OK
OPERATE
3.00
mbar
+
–
–>
Adjustment elements
4.3 Setup with module "Menu-driven adjustment with additional functions“
The adjustment with the multifunctional mod-
ule is menu-orientated and is made via the
four keys in conjunction with the text display.
The move from the measured value indication
to the main menu is made with the "OK“ key.
Use the "
→
“ key to change within a menu
from one menu item to another.
Branching points
A branching point is shown by the ▼ symbol
and enables a jump to the menu below with
the "OK“ key. In this menu you can find pa-
rameters which are linked (possibly in other
submenus).
Parameters have no ▲ or ▼ symbol. The
value of the parameters can be modified with
the "+“ and "–“ keys or chosen from the list.
When these keys are pushed once, the value
flashes first. When pushed again, the value is
modified. The modified value can be saved
with the "OK“ key. Push the "
→
“ key to inter-
rupt input (without saving the modification).
Certain parameters can be displayed but not
modified.
Setup
Reset
A reset is shown by the ▲ symbol and ena-
bles a jump back to the menu above with the
"OK“ key.
Automatic jump back to measured value
indication is triggered 60 minutes after the
last key push.