Warrior 2360 LICENSE PLATE HAWSE MOUNTS (Universal) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
LICENSE PLATE HAWSE MOUNT
INSTALLATION INSTRUCTIONS
WAR 2360
Before Beginning: This kit was built around a standard _” thick hawse. If your hawse is thicker or
uniquely shaped you may not be able to use this bracket. It was also built with the intent to fit around a
flat faced bumper opening.
1. Begin by unpacking your kit. You should find two different plates, two plastic handled knobs,
and an assortment of bolts and nuts.
2. Begin by bolting your base plate (shaped similar to your aluminum hawse) behind the hawse on
your bumper or winch plate. The two bent ears on the bracket should face forward on the top.
3. Slide your license plate over the 4 threaded studs on the license plate mount.
4. Affix a flat washer, external lock washer, and then an acorn nut to each stud to hold the license
plate in place.
5. To install and uninstall your license plate. Hold the plate mount over ears on the mount now
bolted to your bumper. Align the top two holes and secure with plastic handled knobs.
For more information on Warrior Products Jeep Parts and Accessories, please visit us on the web at
www.warriorproducts.com . If you need further assistance installing your product, please contact us by
email at [email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS