Warrior 3530 Front Bumper (2007-2013 FJ Cruiser) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
FJ Cruiser Front Bumper
INSTALLATION INSTRUCTIONS
WAR 3520/3530
The Warrior Products 3520 & 3530 FJ Cruiser bumpers are designed to fit non-integrated, solenoid
winches. Although the bumper has a fairly roomy interior for winch fitment, Warrior Products
makes no guarantees to the compatibility of every winch. If you are installing a winch at the same
time as the bumper, you must install the winch prior to mounting the bumper to the vehicle. When
fitting the bumper it is a good idea to have a helper available as the bumper can be a bit cumbersome
and heavy for one individual to handle alone, particularly when pre-fitted with a winch.
1. Begin the installation by removing the OEM grill, front bumper cover and all associated trim
pieces outlined below.
a. Temporarily remove the headlight surround/grill by accessing the push-pins and screws
along the top side and some clips along the bottom inside. Lift it out of the way and set it
aside.
b. Remove the stock plastic bumper cover by accessing the push-pins along the topside and
the lower bumper retaining screws and a couple screws located in the forward edge of
each wheel well.
c. The ends of the plastic cover can now be flexed out and then the entire cover moved
away and down off of the bumper reinforcement bracket.
d. Remove the inner bumper reinforcement bracket with extensions and retain the nuts for
installation of the Warrior bumper.
e. Remove the front bumper upper retainer.
f. Remove the molded plastic front bumper side supports; one on either side.
g. The inner fender well liners will have a
triangular ‘bowled’ section hanging freely
once they have been unscrewed from the
plastic bumper cover. At your discretion,
trim these sections off near the fender well
ceiling.
h. The front fenders will now need to be
reattached to the body. Snap the square
nylon nut into the square hole visible after
removing the molded plastic front bumper
side supports and use the provided _” x _”
bolt with _” flat washer to fasten the front
fender mounting tab back onto the body.
2. The vehicle should now be ready for installation of the Warrior bumper.