Warrior 871 SAFARI CANOE RACK (1987 – 1996 Jeep YJ Wrangler) User Manual
Read all instructions before proceeding, Safari canoe rack
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
SAFARI CANOE RACK
INSTALLATION INSTRUCTIONS
WAR 848/871
'87 - '96 YJ Wrangler, CJ7, & ’97 & Up TJ
Read all instructions before proceeding.
Due to welding, handling, shipping, etc., the Light Bar legs may need to be “tweaked” slightly (bent in or out) to fit
correctly. A small amount of twisting will not hurt the bar. Be careful not to scratch the paint as you install the legs.
NOTE: The nut plates on some Jeep windshields may come loose when both bolts are removed at the same time.
Loosen both bolts, remove one, install bracket with one bolt, spin out of the way and remove other bolt.
Try to keep one bolt engaged through the windshield at all times.
1. Remove the 2 screws on the upper outboard side of the drivers side windshield hinge. Repeat for the
passenger side hinge as well. New screws are provided.
2. Assemble the front Light Bar by inserting windshield mounting brackets onto the short light bar hoop
and inserting snapper pins to hold in place. The light tabs should be facing forward and the windshield
mounting brackets towards the rear of the vehicle.
3. Place the front Light Bar assembly onto the windshield. Install screws through the Light Bar mounting
brackets.
4. Assemble the rear Light Bar by inserting lower mounting brackets onto the Light Bar hoop and
inserting snapper pins to hold in place. The light tabs should be facing rearward.
5. Position the light bar assembly so that both mounting brackets are even with the top of the body tub and
the rear edge of the rear bracket is approximately 3/4" rearward from vertical body seam. The two pairs
of horizontal and vertical holes should straddle the vertical seam, and the vertical holes should straddle
the horizontal seam. Make sure the rear reinforcing plates fit next to the inside body seams. Mark
where the holes are to be drilled and then remove the rear hoop.
6. Drill 3/8" holes where marked. Reinstall the rear Light Bar assembly. Install provided bolts through
the body tub using the reinforcing plates on inside of the tub, and tighten loosely. Use of the bottom
bolt on the rear mounting brackets is optional to provide extra rigidity and does require installation of
the backing plate and nut from beneath the vehicle.
7. Lights should be installed per the manufacturer’s instructions.
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS