Warrior 30521 ZJ Grand Cherokee 2” Spacer Lift Kit (1993 – 1998 Jeep Grand Cherokee ZJ) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
SUBJECT: Part #30520 & #30521 ZJ Grand Cherokee 2” Spacer Lift Kit
IMPORTANT: Please read all instructions before beginning
FRONT INSTALLATION
1. Park the vehicle on a level surface and chock the tires. Jack the vehicle up in front and support with jack
stands.
2. Remove the front tires
3. Unbolt and remove the front shocks
4. Place a floor jack underneath the front axle and jack the axle up slightly to put a load on the front springs.
5. Unbolt the sway bar endlinks from the swaybar. Retain hardware, it will be re-used.
6. Remove the coil spring retainers on the axle end of the coil spring. These will be re-used.
7. Lower the jack to unload front coil springs. Go as low as you can, but do not completely remove jack. It
must remain under the axle.
8. Remove the front coil springs. You shouldn’t need it, but a spring compressor tool may make this easier.
9. Remove the factory bump stop. To do this, use a pair of channel lock pliers to pull the rubber out of the
bump stop, and then remove the mounting cup by simply unbolting it.
10. Install coil spacers included in the kit. The tapered point on the spacer should point downward. You may
need to tap them into place with a rubber mallet.
11. Re-install the bump stops that you removed in step 9.
12. Re-install the front coil springs.
13. Jack up the axle to put a load on the springs. Re-install your coil spring retainers and sway bar endlinks.
14. If you purchased kit #30520 or chose any other new aftermarket shocks, install them now. Otherwise, re-
install your existing shocks.
15. Re-install your front wheels and tires. Remove the jack stands and lower vehicle to the ground. Torque
your lug nuts to factory specification.
REAR INSTALLATION
1. Chock the front tires and jack up the rear of the vehicle. Support with jack stands and remove rear tires.
2. Support the axle with your floor jack.
3. Unbolt your sway bar endlinks from the axle mounts.
4. Unbolt and remove the shocks.