Warrior 3550 Rear Bumper (2007-2013 FJ Cruiser) - Manual

Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected] Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
FJ Cruiser Rear Bumper
INSTALLATION INSTRUCTIONS
NOTE: To fit the Warrior Products 3540 or 3550 FJ Cruiser rear bumper you must remove (i.e. cut) the
plastic corner panels free from the rear bumper cover and reattach them utilizing the OEM rear corner
retainers. For a much cleaner appearance, Warrior Products offers 3915 & 3920 FJ Cruiser Rear Corner
Guards as armored replacements to the factory plastic corners.
1. Begin the installation by removing
the OEM rear bumper cover /
corners and all associated trim
pieces. Remove the 5 screws along
the top step of the bumper cover and
4 screws on the underside. Lastly,
locate and remove the push-pins on
the inner tailgate edge of the plastic
corner panels. Disconnect the
backup sensor wiring and/or trailer
harness bracketry if equipped.
2. Begin removal of the rear bumper cover taking care not
to break any mounting tabs of the plastic corner panels.
Remove the rear bumper energy absorber, side stays,
side support sub-assemblies, rear bumper bar brackets
and the tow point.