Warrior 1519 TUBE DOOR MIRROR BRACKET (Universal) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
TUBE DOOR MIRROR BRACKET
INSTALLATION INSTRUCTIONS
WAR 1519
NOTE: These mirror brackets will fit all JK Wrangler Front Tube Doors as well as Front Tube Doors
for all Cherokee XJ Models. This kit includes mirror to be used in the installation.
Installation:
1. These brackets mount to the outside of the triangular gusset located on the top hinge pin of your
tube doors. They should be located so that the tube on the mirror bracket sits outside of the door
when installed on the vehicle.
2. Start by aligning the brackets on the gusset of the tube door and marking the locations to be
drilled. A silver or white colored pencil draws very well on the black powder coat. You should
be marking 3 holes on each side for a total of 6 holes.
3. Drill the marked holes with a 9/32” drill bit. To do this it is recommended that you first center
punch the marked holes so that the drill bit does not wander. You can choose to use some flat
black paint to retouch the drilled holes. Allow to dry completely before continuing.
4. Using the six bolts and nylock nuts included in your kit, bolt the brackets onto the tube door
gusset. The two short bolts go behind the mirror tube mounts, one for each side.
5. The included mirrors may have a 3-hole patterned bracket on the bottom. If they do, remove that
bracket by removing the two nuts holding it on in the bottom of the mirror arm. Retain the two
nuts and flat washer.
6. Install the mirrors onto the brackets by sliding the bottom of the mirror arm over the tube on the
bracket. The threaded portion of the bottom stud will slide thru the hole and be accessible from
the bottom of the brackets. Use the flat washer and nut you removed earlier to attach the mirror
to the bracket. Tighten to a snug fit.
7. Sitting in your driver seat with the tube door closed; set the mirrors angle to the desired position
and lock it into place by tightening the mirror to the bracket securely. Do not over tighten as you
may damage your mirrors.
8. Finish the installation by hand adjusting the mirror lens to your preferred position.
Warrior also carries a full line of mesh covers, padding kits, and door limiting straps for your Tube
Doors. Check out
www.warriorproducts.com to view additional accessories available for your tube
doors.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS