beautypg.com

Warrior 2990 TAIL LIGHT BOX (2007 – 2013 Jeep JK Wrangler) User Manual

Page 2

background image

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364

[email protected]
www.warriorproducts.com

6. Cut out the rear of the JK tub to allow for clearance for the 4” LED tail light. This is a trial and error fit.

Photo on the right is the finished result.

7. Install the rubber lip seal around the tail light boxes, cut the ends to desired result. For the outer two

holes use the supplied plastic spacers on the back side (inside of the tub) of the 3” long bolt with the
angled surface against the body metal. These will allow the _-20 3” long bolt to sit straight so that they fit
flat against the light box.

8. Tighten all four bolts, connect the wires and install the LED lights.

Thanks for purchasing Warrior Products! Please see our other Jeep accessories at

www.warriorproducts.com

.