Warrior 2205 – Locking Security Trunk (2007 – 2013 Jeep JK Wrangler) - Manual (Page 3)

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
15. Align the lid so that it is centered on the box side to side, and so that the hinges edge touches the rearmost edge of
the box. Once aligned you will need to drill the 4 holes to pop rivet the lid onto the floor.
16. The final portion of this installation will be to install the remaining trim over the top edge of the box, so that it
covers the rivets and seals to the lid when closed. You will need to cut 45° angles in it to once again make that
picture frame style rectangle. Below is an image of what your finished result should look like.
17. Complete this installation by buttoning up a few items. Re-install your subwoofer if your vehicle has one. Also, the
drain hole in your new security trunk accepts the drain hole in your factory storage compartment. Pull this rubber
plug out of the factory compartment and install it into the new trunk.
This completes the installation of your new Warrior Products JK Locking Security Trunk. If you want to see what else
Warrior has to offer, please visit us online at
www.warriorproducts.com . If you need further assistance installing your
product, please contact us by email at [email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS