Warrior 3915 TOYOTA FJ CRUISER REAR CORNER GUARDS (2007-2013 FJ Cruiser) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
7. There are two small holes per side that will need to be drilled into
the body to attach the ends of the brackets where no factory holes
are provided. Locate these positions and use a 1/8” drill bit then
attach the ends of the brackets using the #10 x _” self-tapping
screws provided.
8. Once the Warrior corner guard brackets have been installed, snap
the square plastic inserts into the square holes on the corner guard
brackets. (six per side)
9. There is a length of rubber fender trim provided to affix trim along
the top and fender-side of each corner guard. For tight corners, cut
a small ‘wedge shape’ from the front and rear sides to allow the
trim to lay flat.
10. Hold the corner guards up to the brackets and visually locate the inserts through the holes in the
corner guards. Use the 6mm x 16mm counter-sunk screws provided to attach the corner guards to
the brackets. Once again, take care not to over-tighten as you risk stripping out the plastic inserts.
Finally, confirm that the installed corner guards do not interfere with operation of the tail gate.
Your Warrior Products corner guards are now installed.
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS