Warrior 30521 ZJ Grand Cherokee 2” Spacer Lift Kit (1993 – 1998 Jeep Grand Cherokee ZJ) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
5. Use the jack to lower the axle to the ground and remove the rear coil springs.
6. Place the coil spring spacers on the rear mounts. Orient them the same way you did during the front
installation.
7. Re-install the coil springs.
8. Jack the axle up and put a load on the coil springs to hold them in place.
9. If you purchased kit #30520 or chose any other new aftermarket shocks, install them now. Otherwise, re-
install your existing shocks.
10. Re-install the rear wheels and tires. Remove the jack stands and lower vehicle to the ground. Torque
your lug nuts to factory specification.
POST INSTALL
1. Check all fasteners for proper torque. Re-check at 100, 500, and 1000 miles.
2. Lifting your 93-98 Grand Cherokee will affect the vehicles toe-in adjustment and steering wheel
alignment. It will be necessary to have your vehicle aligned post-install.
3. Warrior Products offers a full line of suspension accessories to further compliment this kit. If you are
interested in upgrading your control arms, bump stop extensions, or any other components, please visit
us online at www.warriorproducts.com
Thanks for purchasing Warrior Products! Please see our other Jeep accessories at
www.warriorproducts.com
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.