Warrior 59950 FRONT WINCH BUMPER (2007 – 2013 Jeep JK Wrangler) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
8. To lengthen the fog light wiring, pull back a few inches of the factory plastic sheathing and cut
the fog light plugs off of the wiring harness. Splice in 14” lengths of 18ga wire onto each wire
from the harness to extend the plugs. Reattach the fog light plugs onto the extended wires and
wrap with electrical tape or shrink-wrap. Replace factory plastic sheathing and give the end a
couple wraps of electrical tape to secure it.
Mounting of the Warrior Bumper
1. As the top winch opening of the bumper is fairly accessible, for ease of installation you may
choose to fit the winch after the bumper has been mounted to the Jeep.
2. With the help of an assistant, lift up the bumper and fit the studs through the frame rail mounting
plates. Hand-thread on the (8) _” flange nuts and visually align the bumper if you are able.
Once you are satisfied with its positioning, tighten the flange nuts with a _” nut driver.
3. Reconnect your fog light wiring and test the lights.
4. Proceed with your winch manufactures’ recommended installation instructions.
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS