Warrior 201 - Baja Tire Carrier (Universal) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
PRE-ASSEMBLY: The first portion of this assembly can be done on a workbench. You will not need to be at your vehicle
to complete this section.
1. Begin by locating the main leg mount plate (F) and the main leg (K). Slide the 5/8” carriage bolt through the
square portion of the hole in part F so that the carriage bolt is pointing straight up. Set the main leg (K) over the
carriage bolt. Use wingnut (L) to tighten the plate to the leg. See illustration.
2. Next, the support legs (B/C) will be bolted to the main leg (K). There are
three holes near the top of the main leg that these will bolt to. The support
legs should sit inside of the main leg. Use six of your 1” allen bolts and lock
nuts to attach the supports to the main. Leave the bolts loose, you cannot
tighten the entire assembly until all parts are together at the end of this pre-
assembly.
3. Next, locate the upper leg support plate (A). This will bolt onto the top of the
support legs using four of the 1” allen head bolts and lock nuts. Make sure
when you install it that the bent tab at the top points up. Again, leave bolts
loose until final assembly.
4. Install the tire support shaft (H) onto the assembly. This piece will slide down the inside of the main leg until the
top hole in the threaded portion lines up with the top hole in the main leg. Use your 2” long allen bolt to bolt thru
the main leg, the tire support shaft, and the vertical tab in the support leg top plate. Use your remaining 1” long
allen bolt through the bottom hole in the main leg where the tire support shaft aligns with it.