VTech CTM-A242SD Manual - Manual (Page 79)

76
Telephone operation
Analog corded/cordless 1-line - CTM-A2510
Handset speakerphone
During a call, press /SPEAKER on the cordless handset to switch between speakerphone mode and handset earpiece mode.
Redial
The last dialed number on the cordless handset or the telephone base is stored for 15 minutes.
To redial the last dialed number from the corded handset:
Lift the corded handset from the telephone base. Listen for a dial tone. Then press
REDIAL.
To redial the last dialed number from the cordless handset:
Press
TALK or /SPEAKER. Listen for a dial tone. Then press REDIAL.
To redial the last dialed number from the telephone base:
Press
/SPEAKER. Listen for a dial tone. Then press REDIAL.
Volume
Listening volume can be adjusted on the cordless handset and the telephone base.
To adjust the listening volume:
During a call on the handset, press -/VOLUME/+ on it to adjust the listening volume. The next call returns to the default
listening volume.
During a call on the telephone base, press
+/VOLUME or -/VOLUME on it to adjust the listening volume. The next call returns to
the default listening volume.
Ringer volume of the telephone base can be adjusted.
To adjust the ringer volume of the telephone base:
When the telephone base is idle, press
+/VOLUME or -/VOLUME on it to adjust the ringer volume.
Call waiting
W hen you hear a call waiting tone during a call, press FLASH on the cordless handset or telephone base to put the current call
on hold and take the new incoming call.
Press
FLASH or the switch hook once rapidly at any time to switch back and forth between calls.
Mute
To mute the microphone:
During a call, press MUTE on the cordless handset or telephone base. The MUTE key illuminates when the mute function is
turned on. You can hear the party on the other end but they cannot hear you.
Press
MUTE again to resume the conversation. The light on the MUTE key turns off.
Hold
When a call is placed on hold, any parallel phone that tries to use the same phone line will take the call off hold and pick the call.
To place a call on hold on the cordless handset:
During a call, press HOLD on the cordless handset. The TALK key on the cordless handset and the HOLD key on the
telephone base flash when the call is on hold.
Press
TALK or /SPEAKER to release the call from hold, or the call will end automatically after the preset call on hold duration.
To place a call on hold on the telephone base:
During a call, press HOLD on the telephone base. The HOLD key flashes when the call is on hold.
Press /SPEAKER to release the call from hold, or the call will end automatically after the preset call on hold duration.
•
•
1.
2.
1.
2.
1.
2.
1.
2.