Telephone settings – VTech CTM-A242SD Manual User Manual
Page 57

54
Analog corded lobby/1-line/2-line/trimstyle - A2100/A2210/A2220/A2310
Telephone settings
Default settings are indicated by asterisks (*).
Setting
Options
Adjustable by:
Handset earpiece volume
(for models
A2210 and A2220 only)
1, 2*, 3, 4
User and administrator
Handset earpiece volume
(for model
A2310 only)
1, 2, 3*, 4, 5
User and administrator
Speakerphone volume
(for models
A2210 and A2220 only)
1, 2, 3, 4, 5*, 6, 7, 8
User and administrator
Ringer volume
Low, Medium*, High
User and administra
tor
Ringer tone
Tone 1*, Tone 2, Tone 3
Administrator only
Flash
(for models
A2210 and A2220 only)
1 (100ms), 2 (300ms), 3* (600ms)
Administrator only
Voicemail voltage detection
(for models
A2210, A2220 and
A2310 only)
Disable voicemail voltage detection,
Periodic low voltage pulse detection method,
Steady high voltage and periodic high voltage
pulse detection method
Administrator only
Ringer tone
There are 3 ringer tone options. For 2-line model (
A2220), changing the ringer tone of either LINE 1 or LINE 2 applies to both
phone lines.
To change the ringer tone:
Turn the telephone base over with the bottom side facing up.
For lobby (
A2100), 1-line (A2210) and 2-line (A2220) models, remove the mounting bracket if it is in desktop position. To
remove the mounting bracket, firmly push both tabs downward and pull up until they release from the grooves.
For trimstyle model (
A2310), remove the mounting bracket. To remove the mounting bracket, firmly press down the tab on it
and pull out to detach it from the telephone base.
Slide the ringer tone switch to select the desired detented position using a narrow object such as a standard screwdriver.
Install the mounting bracket accordingly.
Flash
For 1-line and 2-line models (
A2210 and A2220), there are 3 flash duration options that can be programmed.
To change the flash duration:
Remove the faceplate and overlay if they are on the telephone base. Press
/SPEAKER on the telephone base or lift the
handset. Then press the recessed
PROGRAM key. The MUTE key flashes when in administrator mode.
Press
FLASH and you hear 3 beeps. Then press a dialing key, 1 (100ms), 2 (300ms) or 3 (600ms), to select the desired flash
duration. Press the recessed
PROGRAM key again. You hear 3 rising beeps as confirmation.
1.
•
•
2.
3.
1.
2.
Ringer tone
switch
Mounting
bracket
(For
A2100, A2210 or A2220)
(For
A2310)
(For
A2100, A2210 or A2220)
(For
A2310)
F
A
X/D
A
T
A
RINGER
VO
L