VTech DS6421-26 Manual - Manual (Page 65)

60
End a PTT call
For a one-to-one PTT call, both the originating and destination handsets
can end the PTT call.
For a PTT call to multiple handsets, the originating handset can end the
PTT call. If any one of the destination handsets leaves the PTT call, the
call continues until all participants or the initiator hangs up.
To end or leave a PTT call:
Press
OFF/
CANCEL
or place the handset in the telephone base or charger.
The handset displays Push to talk Ended.
Answer an incoming call during a PTT call
When you receive an incoming outside call during a PTT session, there is an
alert tone. The PTT screen and the caller ID information display alternately.
During a one-to-one PTT, press /HOME/
FLASH
or /CELL on the
originating or destination handset. The PTT call ends automatically and
the outside call is answered.
During a PTT call to multiple handsets, press
/HOME/
FLASH
or /CELL
on the originating handset. The PTT call ends automatically and the outside
call is answered.
During a PTT call to multiple handsets, press
/HOME/
FLASH
or /CELL
on any one of the destination handsets and that handset answers the
outside call. The PTT call continues for the rest of the PTT participants.
To leave the PTT call without answering the incoming call, press
OFF/
CANCEL
. The telephone continues to ring.
Make an outgoing call during a PTT call
During a one-to-one PTT call, press /HOME/
FLASH
or /CELL to get a
dial tone. The PTT call ends automatically.
During a PTT call to multiple handsets, press
/HOME/
FLASH
or /CELL
on the originating handset. The PTT call ends automatically and you get a
dial tone.
During a PTT call to multiple handsets, press
/HOME/
FLASH
or /CELL
on any one of the destination handsets and that handset gets a dial tone.
The PTT call continues for the rest of the PTT participants.
•
•
•
•
•
•
•
•
•
After PUSH TO TALK is released, the PTT call remains open for a short time.
If no one presses PUSH TO TALK within 10 seconds, the PTT call
ends automatically.
Multiple handset use