VTech DS6421-26 Manual - Manual (Page 29)

24
Replace an active device
If you already have two active devices on the device list
and you want to activate a different device, you must
deactivate one of the two active devices.
To replace an active device:
Press MENU on the handset when it is not in use.
Press or to highlight Bluetooth, then
press SELECT .
Press or to highlight Device list, then
press SELECT .
Press or to highlight the device you want to
activate, without a prefix D1: or D2:, then
press OPTION .
Press or to highlight Connect, then press
SELECT . The handset displays Only 2 devices can
be ready for connection and then a list of devices
for deactivation.
Press or to highlight the device to be deactivated,
then press NEXT . The handset displays
Cell Phone/Headset A is deactivated and you hear a
confirmation tone. The handset displays Connecting
Cell Phone/Headset B to the base...
Depending on your cell phone settings, you may
need to press a key on your cell phone to confirm
the connection. When the new device is successfully
activated and connected, the handset displays Device
connected. You hear a confirmation tone.
Bluetooth connection from idle mode
When you have active devices that are not connected,
CONNECT appears on the idle handset. Press CONNECT
to start connecting an active device. When there are two
active devices, the handset will prompt you to choose one
before connection.
1.
2.
3.
4.
5.
6.
7.
Bluetooth
DEVICE LIST
D1:Headset A
D2:Cell Phone A
Cell Phone B
Cell Phone C
BACK OPTION
1
BLUETOOTH
Add device
Device list
Download dir
Change PIN
BACK SELECT
HANDSET
--:-- --/--
CONNECT MENU
1
1
Cell Phone B
Connect
Remove
Rename
BACK SELECT
1
Connecting
Cell Phone B
to the base...