VTech DS6421-26 Manual - Manual (Page 26)

21
Connecting devices
Up to four devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be in an active slot
( D1 or D2) on the device list and connected. Only one Bluetooth cell phone or
a headset can be on a call at a time.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
Review the device list
Press MENU on the handset when it is not in use.
Press or to highlight Bluetooth, then
press SELECT .
Press or to highlight Device list, then
press SELECT .
Connect/Disconnect an active device
While in the device list menu, you may connect or
disconnect your devices.
Press MENU on the handset when it is not in use.
Press or to highlight Bluetooth, then
press SELECT .
Press or to highlight Device list, then
press SELECT .
Press or to highlight a device when necessary,
then press OPTION .
Press or to highlight Connect/Disconnect
(whichever is applicable), then press
SELECT to confirm. The handset displays Device
connected/Device disconnected. You hear a
confirmation tone.
1.
2.
3.
1.
2.
3.
4.
5.
When your device is connected, you will be prompted to
select Disconnect. When your device is disconnected,
you will be prompted to select Connect.
When connecting a Bluetooth device to the device list, all connected devices
will be temporarily disconnected until the procedure is complete. It may take
up to two minutes to reconnect.
BLUETOOTH
Add device
Device list
Download dir
Change PIN
BACK SELECT
DEVICE LIST
D1:Headset A
D2:Cell Phone A
Cell Phone B
Cell Phone C
BACK OPTION
1
Headset A
Connect
Remove
Rename
BACK SELECT
1
Answering sys
Directory
Caller ID log
Intercom
Bluetooth
BACK SELECT
Bluetooth