VTech SN6127_-2 Manual - Manual (Page 9)

Getting started
3
Handset charger installation and charging
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service
to digital service from a cable company or a VoIP service provider, the
telephone line may need to be rewired to allow all existing telephone jacks
to work. Contact your cable/VoIP service provider for more information.
•
•
If the handset will not be used for a long time, disconnect and
remove the battery to prevent possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or dial 1 (800) 267-7377.
•
•
Stays red when
put in charger.
Install the charger as below. 1. Place the handset in the
telephone base or handset
charger to charge.
2.
Electrical outlet
not controlled
by a wall switch
Handset charger
power adapter