VTech SN6127_-2 Manual - Manual (Page 10)

Getting started
4
Handset battery charging
Once you have installed the battery, the handset indicates the battery
status (see the table below). If necessary, place the handset in the
telephone base to charge the battery. For best performance, keep the
handset in the telephone base when not in use. The battery is fully
charged after 11 hours of continuous charging.
If the screen is blank or displays
Place in charger, you need to charge
the handset battery without interruption for at least 30 minutes to give the
handset enough charge to use for a short time. When the battery is low,
the handset displays Low battery along with a flashing icon. If you are
on a call in low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and
actions to take.
Battery indicators Battery status Action
The screen is blank, or
displays Place in charger
and flashes.
The battery has no or
very little charge. The
handset cannot be used.
Charge without
interruption (about
30 minutes).
The screen displays
Low battery and
flashes.
The battery has enough
charge to be used for a
short time.
Charge without
interruption (about
30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base when
not in use.
If you place the handset in the telephone base without installing a
battery, the handset displays No battery.
After you install your telephone or power returns
following a power outage, the handset will prompt
you to set the date and time. For instructions, see
Set date and time on page 22. To skip setting,
press CANCEL.
SET DATE
MM/DD/YY