Veris Technologies 3100 Soil EC Mapping System (1997-2008 CF card drive 1.77D) - Operating Instructions User Manual

Page 4

Veris Technologies

Pub. #OM 1CM02-1

Make sure that you have received all of these components in your EC Package.

Mount instrument in a location that is as free as possible from dust, vibration, and electrical
interference. Display should be visible to operator and shielded from direct sunlight.

Below is a rear view of the instrument

Serial Port for Serial Port for

Power Power cable

Signal Port

GPS Signal

Listening Computer

Switch Port

For signal cable

or Test Load

Connect GPS cable to GPS INPUT serial port on back of instrument. The Veris instrument is
designed to accept GPS input in NMEA format via an RS232 connector. Note: GPS signals are
frequently affected by electrical interference from magneto electrical systems. If your vehicle uses a
magneto, consider powering the Veris instrument with a 12-volt battery or converting to an alternator
system.

The Veris 3100 is shipped with an accessory power plug. If an alternative connection is desired,
make sure that the unit is properly connected to a power connection that is not controlled by the
ignition switch. If connecting directly to the battery, we suggest a 3 amp. in-line fuse is installed
between the battery and the instrument. Important

– Do not allow moisture to enter the

instrument, and do not pass strong magnets near the unit.

Signal Testing

– The Veris 3100 is shipped with an Instrument Test Load (Part No. 10447) that will

enable you to quickly check the instrument to ensure that it is functioning properly. To perform this
test, do the following:

1) Disconnect the signal cable from the 9-pin (signal) terminal on the instrument.
2) Connect the test load to the signal terminal.
3)

Switch on the unit and go into “data acquisition” mode.

4) The display should show: (approx.)

Shallow

Deep