TROY Group MICR_IRD M600 series Security Printing Solutions Quick-Start Guide - Manual (Page 5)

Security Printing Solutions
Quick-Start Guide
Document #50-70436-001 Rev. C
Page 5 of 13
Figure 1 Figure 2
STEP 3:
Install the TROY Support Files for Microsoft
®
Windows
™
NOTE: The Hewlett-Packard PCL 5e printer driver must be installed on the host computer prior to loading the
TROY support files (refer to STEP 2 on the previous page).
The TROY metrics file contains the required escape sequences that are used to “call” the TROY security and/or
barcode fonts installed in the TROY Security Printing Solution (via the TROY Memory Card). When properly
installed, the TROY metrics file will be associated with the PCL 5e printer driver used by your TROY printer to
enable printing of the actual fonts installed in the printer. By associating the metrics file with the printer driver,
the TROY TrueType screen fonts will be automatically replaced with the actual TROY fonts at print time. If the
TROY metrics file is not properly installed, then the TROY TrueType screen fonts will print instead of the
actual TROY installed printer fonts.
Install the TROY Metrics File for Windows
™
98SE and ME Operating Systems
1. Close all applications before installing the TROY Font support files.
2. Insert the TROY Security Printing Solutions CD into your computer CD-ROM drive.
3. From the Microsoft Windows Start menu, click on Settings, and then click on Printers.
4. Right-click on your TROY Security Printing Solution icon, and then click on Properties from the pull-
down menu. If multiple printers are installed, make sure the correct printer icon is selected that
corresponds to your TROY Security Printing Solutions printer.
5. Click on the Configure tab located at the top of the Properties window.
6. Within the Other Options category, click on the More button. Some printer driver versions may not
display the Other Options category. If this is the case, simply skip to the next step.
7. Within the Fonts category, place a check mark in the Font Cards checkbox, and then click on the
Configure button (with some printer driver software versions, the Configure button may already be
“clicked”). A new window will open labeled Configure Font Cards.
8. Click on the Add button to open the Add Font Card window.