Siemens TK69001 - Manual (Page 41)

41
The current time is programmed with this function.
This is required when using the timer function.
q Hold down button
% on display 3 for at least 3 seconds.
q Select TIME with < or >.
q Press button
% , hours display flashes.
q Change the setting with < or >.
q Press button
% , minutes display flashes.
q Change the setting with < or >.
q Press button
% to save the setting.
q Press the 6 button. Back to standby.
The set time will be deleted
- if the mains plug is pulled out,
- if the appliance is switched off with the mains switch 1,
- if there is a power failure.
The current time must be input again.
The time at which the appliance will automatically switch
on can be set with this function.
q Hold down button
% on display 3 for at least 3 seconds.
q Select ON AT with < or >.
q Press button
% , hours display flashes.
q Change the setting with < or >.
q Press button
% , minutes display flashes.
q Change the setting with < or >.
q Press button
% to save the setting.
q Press the 6 button. Back to standby.
DeĆactivating the setting:
q Set the time to --:-- with < or >.
Note: The current time must be set for this function to run.
i The switchĆon time is retained even if there is a power
failure or the mains switch 1 is actuated.
Current time
TIME
--:--
ДДДДДДДДД
ДДДДДДДДД
ДДДДДДДДД
TIME
14:39
Timer
ON AT
--:--
ДДДДДДДДД
ДДДДДДДДД
ДДДДДДДДД
ON AT
07:45