Ohaus RANGER COMPACT COUNTING SCALES Manual en - Manual (Page 32)

Ranger RC
32
Settings in the menu
4.6.3 COM1/COM2 -> PARAMET – communication parameter
4.6.4 COM1/COM2 -> RESET COM1/RESET COM2 – resetting serial interface to factory
settings
4.6.5 OPTION – configuring options
If no option is installed or is not yet configured, N.A. appears in the display.
bAUd Selecting baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400 baud
PAritY Selecting parity: 7 none, 8 none, 7 odd, 8 odd, 7 even, 8 even
H.SHAKE Selecting Handshake: NO, XONXOFF, nEt422, nEt485 (network operation
as per RS485 standard via the optional RS422/RS485 interface, only for COM1)
NET.Addr Assigning network address: 0 ... 31, only for NET 485
ChECSuM Activating checksum byte (appears only in TOLEDO Continuous mode)
Vcc Switching 5V voltage, e.g. for a bar code reader, on / off
SUrE?
Confirmation inquiry
• Reset interface settings to factory settings with Yes
• Do not reset the interface settings with No
EtH.NEt
Configuration of the Ethernet interface
IP.AddrS • Enter IP address
SUBNEt • Enter Subnet address
GAtEWAY • Enter Gateway address
USb Configuration of the USB interface
USb TEST • Test of the USB interface. After the test has been passed, rEAdY appears in the
display.
diGitAL Configuration of the digital inputs/outputs
IN 1 ... 4 Configuring inputs 1 ... 4
OFF • Input not assigned
ZErO • ZERO Key
tArE • TARE Key
PriNt • PRINT Key
rEF 10 • Sample 10 Key
rEF n • Sample Size Key
SCALE • Scale Select Key
UNIt • Count Weight Key