Ohaus RANGER COMPACT COUNTING SCALES Manual en - Manual (Page 28)

Ranger RC
28
Settings in the menu
4.3.8 FACT – automatic temperature-dependent adjustment
This menu item appears only on scales with an internal calibration weight.
4.3.9 MIN.WEIG – minimum weight
This menu item appears only if the service technician has saved a minimum weight.
4.3.10 RESET – resetting scale settings to factory settings
4.4 Application settings (APPLICATION)
4.4.1 COUNT – settings for counting
TEMP Defining the temperature difference for automatic calibration
OFF • Switching off automatic calibration in the case of a temperature difference
1K/2K/3K/5K • Automatic calibration in the case of a temperature change of 1 K, 2 K, 3 K or 5 K
since the last adjustment
ON/OFF Switching minimum weight function on/off
If the weight on the scale falls below the stored minimum weight, an * appears on
the display in front of the weight indicator.
SUrE? Confirmation inquiry
• Reset the scale settings to factory settings with Yes
• Do not reset scale settings with No
VAr-SPL Adaptation of the reference quantity
ON • The reference quantity can be changed in operating mode
OFF • Counting only with defined reference quantities
SPL-qtY Reference quantity
Sq1 ... Sq5 • Define 5 fixed reference quantities
Min.reFW
Monitoring the minimum reference weight
OFF • No monitoring of the minimum reference weight
97.5, 99.0,
99.5
• Monitoring the minimum reference weight so that a counting accuracy of
97.5 %, 99.0 % or 99.5 % is achieved
rEF.OPt
Optimizing the average piece weight
OFF • No reference optimization
AUtO • Automatic reference optimization