Trooper count scale, 5 setup menu procedure – Ohaus TROOPER COMPACT COUNTING SCALES Manual multi User Manual
Page 22
18
Trooper Count Scale
4.5 Setup Menu
Procedure
With the Scale ON, press and hold theSAMPLE Menu
button until CAL MENU is displayed.
NOTE: The calibration menu is covered in Section 5.
Press M- button to advance to SETUP MENU, then
press Enter button. Navigate through the menu as
explained in section 4.3.1.
Press Enter button to get into the RESET sub-menu.
YES will change all menu settings to their default set-
tings. Library data will not be affected.
ON will set the Scale to LFT configuration. In the ON
setting, the zero setting will be limited to +/- 2%. In
the OFF setting, the zero setting is 100%. Also, in the
ON setting, the LFT readability is set. In the OFF posi-
tion, the readability is set to the Enhanced value.
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
BLINKING
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
BLINKING
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
Three setting are available, ALL, SIGNAL and OFF.
ALL = the beeper sounds when buttons are pressed or
when error or target signals are needed. SIGNAL =
beeps on errors (three beeps) or at count target (con-
tinuous). OFF = is always off.
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
kg
g
lb
oz
Net
B/G %Ac
T
PT APW MR
M
<
>
PCS
WEIGHT
DATA
COUNT
Selected calibration units are either lb or 1000g (kg).
A selection of 1/3, 2/3 or full span calibration values
are available. The numeric values of the calibration
points are displayed for the specific Scale capacity
and calibration unit.
Backlight has three available settings; ON, OFF, AUTO.
ON = backlight is always on. AUTO = backlight turns
on with any key press or a weight change (5d) and
remains on for 5 seconds. OFF = backlight is always
off. OFF or AUTO is recommended for battery opera-
tion.
ON = Scale turns off in 5 minutes if no key press or
weight changes (5d) are detected. OFF = auto off
feature is disabled. ON is recommended for battery
operation.