Ohaus TROOPER COMPACT COUNTING SCALES Manual multi - Manual (Page 11)

7
Trooper Count Scale
3.2 Basic Weighing
The Trooper Count Scale has been factory calibrated and is ready for operation. Ohaus recommends that the Scale be
re-calibrated before use to ensure optimal accuracy. You can operate the scale at this point using the factory default
settings. You can check the default menu settings on page 14. All bolded items on the menu are the factory default
settings. The scale will operate in the default mode. If you want to change the settings, continue with Section 4, Setup.
When the Scale is positioned for operation, follow the operational procedure outlined next.
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT
3.2.1. Turning On the Scale
Press and hold ON/ZERO Off button until the LCD
display appears. The display cycles as shown below
displaying "Ohaus", with model number, serial num-
ber, software revision number and weighing mode
display.
3.2.2 Turning Off the Scale
To turn the Scale off, press and hold the ON/ZERO Off
button until OFF is displayed.
3.2.3 Zero Operation
Press the ON/ZERO Off button to zero the weight dis-
play. The gross weight is also shown in the DATA
display.
NOTE: A pre-set tare value will not be zeroed.
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT 3.2.4 Weighing
Place item to be weighed on the Scale. The display
indicates a sample of 1.5kg, gross weight.
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT
kg g lb oz Net B/G %Ac T PT APW MR M < > PCS
WEIGHT DATA COUNT