Ohaus TROOPER COMPACT SCALES Manual multi - Manual (Page 22)

EN-16
Trooper Scale
UNITS SELECTION
Press G/N/T/ MENU button, Un OFF g is displayed.
Press PRINT/ UNITS button, and select ON or OFF. OFF is
the default setting.
Press G/N/T/ MENU button, Un ON lb is displayed. This
is unit pounds which can be turned ON or OFF. This will
be displayed when CAL UNIT kg was selected. When lb
was selected as calibration unit, kg will display.
Press PRINT/ UNITS button,and select ON or OFF. ON is
the default setting.
Press G/N/T/ MENU button, Un ON oz is displayed.T h i s
unit is ounces which can be turned ON or OFF. Default
setting is ON.
Press PRINT/ UNITS button,and select ON or OFF.
NOTE: If CAL Unit is kg, then UNIT kg is fixed to ON menu
not shown. The same if CAL Unit is set to lb.
4.4.4 Readout Menu (Cont.)
Procedure
AUTO ZERO
Press G/N/T/ MENU button, AZt 0.5 is displayed. This is
the Auto Zero Threshold setting. Auto Zero minimizes the
effects of temperature changes and small disturbances
on the zero reading. The Scale maintains the zero dis-
play until the threshold is exceeded. Settings are shown
as follows:
OFF
0.5d Sets threshold to 0.5 divisions. - Fixed in LFT
1d Sets threshold to 1 division.
3d
Sets threshold to 3 divisions.
Factory default setting is 0.5d.
Press PRINT/ UNITS button,and select either 0.5, 1 or 3.