Ohaus DISCOVERY SEMI-MICRO AND ANALYTICAL BALANCES Manual - Manual (Page 34)

EN-30 Ohaus Discovery
3.6 Additional Features
3.6.1 Weigh Below
The Discovery balance is equipped
with a weigh below hook.
Note: Before turning the balance
over, remove the pan, wind shield
and shield to prevent damage to the
glass doors.
To use this feature, remove power
from the balance and remove the
protective cover for the weigh below
opening as shown. Install the
weigh below hook.
The balance can be supported using
lab jacks or any other convenient
method. Make sure the balance
is level and secure. Use a string or
wire to attach items to be weighed. Bottom View of Balance
Balance With Weigh Below Hook Installed
Weigh Below Hook
Table Support
Weigh Below
Protective
Cover
3.7 Balance Settings
3.7.1 Menu Setup
Pressing the Menu button allows access to the menus shown below. Each menu contains additional sub-menus that are used to set the
balance parameters. This section of the manual contains all menus and descriptions required to set all parameters for the Discovery balance.
Please review the contents of each menu to get a better understanding of the balance’s capabilities before attempting to operate the balance.
The diagram below illustrates the main menu in the balance.
Main Menu Sequence
A long press of the Menu button will access the Main Menu.
Press the Yes button to enter the menu.
Press the No button to advance to the next menu selection.
Press Exit to return to the application mode.