Ohaus FD Series STAINLESS STEEL COMPACT SCALES Manual multi - Manual (Page 15)

EN-9 FD Series
3.2 Control Functions
Four multi-function buttons are used to operate the scale.
3.3 Basic Operation
3.3.1 Turning On
With the scale off, press the ON/ZERO Off button. The scale performs a display test, then displays
zero.
3.3.2 Turning Off
With the scale on, press and hold the ON/ZERO Off button until OFF is displayed.
3.3.3 Z e r o i n g
Remove the load from the pan and press the ON/ZERO Off button to set the display to zero. The
Center of Zero indicator turns on when the measurement is within ±1/4 d of the zero setting.
3.3.4 Taring
Semi-automatic Tare (Tare Button)
To store or change the Tare value, place an empty container on the pan and press the TARE button.
The Net weight and NET indicator will be displayed.
To clear the Tare value, remove the container from the pan and press the TARE button. The NET
indicator turns off and the gross weight will be displayed.
Button
Primary
Function
(short
press)
Secondary
Function
(long press)
ON / ZERO
• If scale is off,
turns scale on
G/N/T
Momentarily
Displays
Gross Net and
Tare values
TARGET
Initiates target
setting mode
TARE
• Sets tare
• Clears tare, if
pan is empty
Off
If scale is on, turns
scale off Units
Changes
weighing unit
Menu
Enters
menu mode
None
Target
Setting
Function Shifts to next
digit
Accepts current
displayed value
Changes sign
(+ / -) of
displayed value
Increments
value of the
active digit
Menu
Function Yes
Accepts current
setting and
advances to the
next menu item
Exit
• Immediately
exits menu
mode
• Aborts
calibration
in progress
No
Rejects current
setting or menu
item and
advances to the
next available
item
Back
Reverts back to
previous menu
item
• If scale is on,
sets zero